Part 4 Glider Model Functions; Set Basic Menu Of Glid - RadioLink AT9 Instruction Manual

Please note that nearly all of the BASIC menu functions are the same for airplane (ACRO setup), sailplane
(GLID 1A+1F/ 2A+1F/ 2A+2F setups), and helicopter (HELI setups). The features that are identical refer
back to the ACRO chapter. The glider BASIC menu includes MOTOR CUT and does not include
IDLE-DOWN or THR-CUT.
○ → Note: in all cases where ACRO programming labels channel 3 as throttle, GLID programming labels
channel 3 as ARB (airbrake), since airbrakes are normally operated on channel 3 in gliders. This includes
STK-THR reading STK-ARB.

4.1 SET BASIC MENU OF GLID

This guideline is intended to help you get acquainted with the radio, to give you a jump start on using your
new radio, and to give you some ideas and direction in how to do with this powerful system.
Goals
Prepare your airplane.
Select the proper MODEL
TYPE for your model.
(Ex:GLID 1A+1F)
[NOTE: This is one of several
functions that require
confirmation to make a change.
Only critical changes such as a
MODEL RESET require
additional key strokes to accept
the change.]
Name the model
Note that you do not need to
do anything to 'save' or store
this data.

PART 4 GLIDER MODEL FUNCTIONS

Steps
Install all servos, switches, receiver per your model's instructions. Turn on
transmitter then receiver; adjust all linkages so surfaces are nearly centered.
Mechanically adjust all linkages to get as close as possible to proper control
throws and minimize binding prior to radio set up.
Check servo direction and throws.
Make notes now of what you will need to change during programming.
In the BASIC menu, open
PARAMETER submenu.
Choose proper MODEL
TYPE.Ex:GLID(1A+1F).
Confirm the change.
Close submenu.
In BASIC menu open the
MODE SEL submenu.
Input airplane name.
Close the submenu.
Inputs
Turn on the transmitter.
BASIC.(If ADVANCE
PARAMETER.
to MODEL TYPE
GLID(1A+1F)
Displays.
to confi rm.
menu.
to MODEL SEL.
character of model's name is highlighted）.
to change the 1
to next character and repeat.
51
for 1 sec. to
again.) to choose
to
，
for 1 sec. Are you sure?
Return to BASIC
to NAME.（1
，
st character. to confirm.
to return.
st