RadioLink AT9 Instruction Manual page 11

（3）Helicopter servo connection
Receiver output
and channel
1
2
Elevator/cyclic pitch
3
4
5
6
Pitch(collective pitch)
7
8
spare/mixture control
9
10
The above listed receiver and channels is referred to the channel 1~9 of the receiver R9D, connect the
receiver with the related servo, you can control the servos by the correspondent switch.
To be clear, the servo connected with the receiver channel 1 is controlled by the radio aileron lever; servo
connected with channel 2 is controlled by elevator lever; servo connected with channel 3 is controlled by
throttle stick; servo connected with channel 4 is controlled by the rudder lever. Channel 5~9 can be self-set
with the related switches by the menu AUX-CH, and the sub menu. For channel 9, the LED indicator on the
receiver flashes red for S-BUS signal and blue for PPM.
Receiver all channels shows:
Helicopter
aileron/cyclic roll
Throttle
Rudder
Spare/gyro
Spare/governor
Spare
spare
RECEIVE INTERFACE
10
CH1(AILE)
CH2(ELEV)
CH3(THRO)
CH4(RUDD)
CH5(GEAR)
CH6(FLAP)
CH7(AUX1)
CH8(AUX2)