Activate BUTTERFLY.
Adjust the aileron and
flap travel to 75%
Elevator setting are
adjustable in the
B.FLY-ELE.
MIX switch is selecable
4.3.9 AILE/ RUDD MIX
You can select a pre-programmed mix which is used to mix the rudders with aileron operation or the ailerons
with rudder operation.
Aileron-to-rudder mix (AILE
Rudder -to-aileron mix (RUDD
with rudder input, especially in knife-edge.
ADJUSTABILITY:
• RATE range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from aileron
(rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the
mix in 2 separate positions of the same SWITCH.
• Condition: The separate AILE
Goals
Open AIL/RUD-MIX
submenu.
Select the mixing mode.
Ex:RUDD-AILE,
Activate the function
25%,no
switch,corrects
roll coupling.
Set the rate (Ex:100%
each way)
Close
ELEV-FLAP mixing (see GLID menu 3.3.7)
4.3.10
4.3.11 AILE-FLAP(GLID 2A+2F only):
Open the BUTTERFLY
function
Activate the function
Adjust the travels as
needed.
(Ex: Aileron each 75%,Flap
75%)
Close
RUDD): automatically creates a "coordinated turn".
AILE): used to counteract undesirable roll (roll coupling) that happens
RUDD setting for each flight condition can be set.
Steps
to BASIC .
to BUTTERFLY,
SWA to UP position
to MIX
to AIL1
to FLP
to AIL2
Inputs
to BASIC .
again to ADVANCE
to AIL/RUD-MIX,
to MODE
,
to RUDD-AILE
to MIX
to ON
,
to RATE
RUDDER STICK
RUDDER STICK
,
58
again to ADVANCE
to OFF
,
to 75%,
,
,
to75%,
,
to 75%,
,
to +25%
to +25%