Camber Mixing - RadioLink AT9 Instruction Manual

Note: When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after
pressing DIAL for 1 second and canceling an alarm display.
Goals
Ex: Set the maximum
travel of 35% of the
total flap travel.

4.3.7 Camber Mixing:

This function adjusts the mixing rate of camber operation which operates the wing camber (ailerons and
flaps) in the negative and positive directions. The aileron, flap, and elevator rates can also be adjusted
independently and attitude changes caused by camber operation can be corrected.
Also the operation reference point of camber control can be offset. (PRE)
Note: Camber control is not assigned at initial.
ADJUSTABILITY:
• Rate: -100% to +100%, with a default of +30%
• Reference point (PRE): The operation reference point of camber control can be offset. -100% to +100%,
with a default of 0%.
Goals
Ex: set the mixing
amount for aileron to
40%, camber control
to VR (E), reference
point to desired
point.
Steps
Open the CAMBER FLAP
function.
Adjust the up/down trim
amount separately.(Ex: adjust
to 35%)
Or: adjust the center position
of flap servo
Close
Steps
Open the CAMBER MIX
function.
Choose desired slider.
Adjust the mixing amount for
AILE. (Ex: adjust to 40%)
Inputs
to BASIC . again to ADVANCE
to CAMBER-FLP,
to FLP
。
VR (A)， to 35%，
VR (A)， to 35%，
Repeat.
to CENTER
，
Inputs
to BASIC .
to CAMBER-MIX,
to VR ， to VrA
to FLP
to VrA ，
to VrA
，
56
。
to desired point.
again to ADVANCE
to 40%,
to 40%，