Spoiler Mix (Glid) - RadioLink AT9 Instruction Manual

This pre-programmed mix is used to create full span aileron action on a glider
with 4wing servos. This increases the roll rate and decreases induced drag. For normal flying, a value of
about 50% is often used. For slope racing or F3B models in speed runs, you may wish to use a larger value
approaching 100%.
ADJUSTABILITY:
• RATE range of -100 to +100. Negative setting would result in opposite aileron action from flaps.
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the
mix in 2 separate positions of the same SWITCH.
• Condition: The separate AILE-FLAP settings for each flight condition can be set.
Goals
Turn on AILE-FLAP
mixing. Set rate to
100% for maximum
possible flap travel
with ailerons .Assign
to SWITCH C center.

4.3.12 SPOILER MIX (GLID):

Moves the spoiler by flipping the assigned switch and is used to make steep decent. SPOILER MIX works
linking with BUTTERFLY MIX.
ADJUSTABILITY:
• Position: -100% to +100%, with a default of -50% (off), +50% (on)
• Channel: Spoiler 1: ch8, or 3 (ch8 or 3*), Spoiler 2: NULL, or 3 (NULL or ch3*) *GLID (2A+2F) mode.
• Elevator setting: Rate: -100% to +100%, Delay: 0% to 100%
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be
Goals
2-servo spoiler mode.
Steps
Open AILE-FLAP submenu.
Activate the function
Set the rate (Ex:100% each
way)
Assign the SWITCH and
position.
Close
Steps
Open the SPOILER MIX
function and move to 2
page.
Inputs
to BASIC .
to AILE-FLAP,
to MIX
to FLP1
AILERON STICK
AILERON STICK
Repeat above to set FLP2
to SW
，
to POSI
Inputs
to BASIC .
nd
to SPOILER - MIX,
59
again to ADVANCE
to ON
，
， to 100%
to 100%
，
to SwC
to UP
，
assigned.
again to ADVANCE