Auxiliary Channel Function (Including Channel 9-10 Controls) - RadioLink AT9 Instruction Manual

Adjustability:
•Each channel may be set independently.
• The NOR (normal) setting holds the servo in its last commanded position.
• The F/S (FailSafe) function moves each servo to a predetermined position.
• NOTE: the setting of the throttle's F/S also applies to the Battery F/S.
• The F/S is used in certain competitions to spin the aircraft to the ground prior to flying away and doing
potential damage elsewhere. Conversely, may also be used to go to neutral on all servos, hopefully keeping
the plane flying as long as possible.
• Competition modelers often maintain the NOR function so that brief interference will not affect their
model's maneuver.
• Set the throttle channel so that the engine idles when there is interference (ACRO). This may give
enough time to fly away from and recover from the radio interference and minimize damage if crashed.
• For helicopters, NOR is typically the safest choice.
• We also recommend setting a gasoline engine's electronic kill switch to the OFF position in the F/S
function for safety reasons.
If you specify a F/S setting, the FailSafe data is automatically transmitted once each two minutes. (PCM)
When you choose the F/S mode, check that your settings are as desired by turning off the transmitter power
switch and verifying that the servos move to the settings that you chose. Be sure to wait at least two minutes
after changing the setting and turning on the receiver power before turning off the transmitter to confirm
your changes have been transmitted.
Goals
Change the receiver
FailSafe command for
channel 8(gasoline engine
kill switch)to a preset
position. NOTE:This is one
of several functions for
which the radio requires
confirmation to make a
change.

2.3.11 Auxiliary Channel Function (including channel 9-10 controls)

(AUX-CH): defines the relationship between the transmitter controls and the receiver output for channels
5-10. Also, the CH9-10 POSI are used to change the CH9-10 servo direction.
Note that the CH9-10 functions are only visible in the AUX-CH screen and modulation mode must be PCM
or 2.4G.
Adjustability:
• channels 5-8 may be assigned to any SWITCH (A-H), LOGIC SWITCH (Lsw1-Lsw3), slider [VR(D)
and VR(E)], or knob [VR(A-C)] (for example, moving flaps to a switch or slider), but not the primary
control sticks (use programmable mixes to do so);
• channel 9-10 may be assigned to any SWITCH (A-H), LOGIC SWITCH (Lsw1-Lsw3) and the servo
【F/S】
CH1：AILE
NOR F/S
Steps
Open BASIC menu,then
Open F/S.
Ch o o s e ch a n n e l to
cha n g e ( E x : C H . 8)
Set and confirm fail safe
conmmand.
Repeat as desired
Close
1：AILE NOR
2：ELEV NOR
3：THRO 15%
4：RUDD NOR
5：GEAR NOR
6：FLAP NOR
7：AUX1 NOR
8：AUX2 NOR
Inputs
for 1s .(If ADVANCE
to F/S, PUSH
to CH8 ,PUSH
that controls CH8 to desired OFF position.
to adjust ,PUSH
27
again) .