Command Sets - Citizen iDP-460 User Manual

Hide thumbs Also See for iDP-460:

Table of Contents

10.2Command Sets

A command set is set by a specific command. The available commands and functions differ depending on

each setting.

(1) P-250 command set

There are two kinds of modes; P-200 mode and P-250 mode. The P-900R mode are available with a P-900R

mode and P-250 mode command. The SI, SO, RS, US, and DC2 command operate differently between the

P-200 mode and P-250 mode.

In the P-200 mode, if the 40th character in the line is received, the contents of the buffer will be printed

automatically. In the P-250 mode, the default delimits at the 42nd character and printing is performed only

after the LF command is received.

(2) P-900R command mode

Basically, this mode is the same as the P-250 mode. It can be set by a command. With the serial interface,

if a paper end error is detected in this mode, "#" will be output as the TD signal every second until the paper

end error is reset.

iDP-460 User's Manual

Table of Contents