Command Sets - Citizen iDP-460 User Manual

10.2 Command Sets

A command set is set by a specific command.
each setting.
(1) P-250 command set
There are two kinds of modes; P-200 mode and P-250 mode.
P-900R mode and P-250 mode command.
between the P-200 mode and P-250 mode.
In the P-200 mode, if the 40th character in the line is received, the contents of the buffer will be printed
automatically.
after the LF command is received.
(2) P-900R command mode
Basically, this mode is the same as the P-250 mode.
interface, if a paper end error is detected in this mode, "#" will be output as the TD signal every second u ntil
the paper end error is reset.
In the P-250 mode, the default delimits at the 42nd character and printing is performed only
The available commands and functions differ depending on
The P-900R mode are available with a
The SI, SO, RS, US, and DC2 command operate differently
It can be set by a command.
30
iDP-460 User's Manual
With the serial
CITIZEN