Print Control Function; Control Command - Citizen iDP-3110 User Manual

8. PRINT CONTROL FUNCTION

8.1 Control Command

1) Print command (CR or LF)
If parallel interface is used, select code CR (0DH) or LF (0AN) on the DIP switch 2.
If the selected code (CR or LF) is input, the data in the print buffer is printed and line feed is performed.
When the serial interface is used, only the CR code becomes effective.
When graphic (mosaic) printing is performed, line feed is not performed by the print command, and graphic (mosaic)
printing is allowed on the next line.
2) Input data cancel command (CAN)
By entering the CAN (18H) code, all data entered prior to the entry of the code on a same line is canceled.
3) Enlarged character printing (SO)
By entering the SO (0EH) code on a specific digit, data entered there-after is output as enlarged characters.
The function is cleared by entering the print code (CR or LF) or DC4 (14H).
The number of printable columns per line for an entire line of enlarged characters are indicated in the table below.
CITIZEN
Model
iDP3110-24*
iDP3110-40*
Number of columns
12 columns
20 columns
24/35
iDP-3110 User's Manual