Citizen iDP-460 User Manual page 52

ESC d
[Name]
[Code]
[Function]
[Caution]
[See Also]
ESC e (n) ;
[Name]
[Code]
[Domain]
[Function]
[Caution]
[Initial Value]
42-columns mode.
Request Printer Status
<1B>H<64>H
In the P-250 mode and P-900R mode, this command sends the following 1-byte status
messages shown below. This command is valid only for the serial interface.
Bit Code
0 L
1 X
2 X
3 X
4 X
5 1
6 F Mechanical error
7 P
This command is ignored for the parallel interface and in the P-200 mode. If the paper
runs out or there is a mechanical error, the data may not be received.
ESC a
Set Right Margin
<1B>H<65H>(n)<3B>H
0 ≤(n) ≤42 (<30>H ≤ n ≤<39>H)
In the P-250 mode and P-900R mode, this command controls whether the characters
should be printed or at which position of the line they should be printed, when the buffer
is full. When the parameter is set between 1 and 41, the printer will print automatically
when the n-th printable character is received. If the parameter is set beyond these limits,
printing will be performed when the LF command is received.
Be sure to add ";"(<3B>H) to the end of the parameter. This command is ignored in other
than the P-250 mode and the P-900 mode.
The characters are printed after the LF command is received in the
P-250, P-900R
Function
Paper end
Not defined
Not defined
Not defined
Not defined
Unused
Without error
Parity
P-250, P-900R
iDP-460 User's Manual
Value
0
With paper Without paper
- -
Fixed at 0
1
Fixed at 1
With error
- -