Citizen iDP-460 User Manual page 49

[Function]
[See Also]
SI
[Name]
[Code]
[Function]
[Caution]
[See Also]
1. Serial interface 7-bit setting
High pages are specified in all the modes. If this command is received, the character
codes 20H to 7FH will be converted into A0H to FFH. This command remains valid
until the SI command or CAN command is received.
2. Serial interface 8-bit setting and parallel interface
This command is ignored in the P-250 mode and P-900R mode. In the other modes, it
sets the double width characters(same as the RS command <IE>H). It prints its
subsequent characters as double width characters.
When there is only one character worth of position in a line, it will be printed in
normal width. This attribute remains valid until the SI command(normal width mode)
or CAN command is received.
In the P-200 mode, this attribute is reset to normal width at the beginning of each line,
every time the line is fed.
RS, US, SI
Set Normal Width Mode or Reset Character Code
<0F>H
This command resets the double width character attribute or high page setting and prints
in normal width or normal character code. The print data received after this command is
printed in normal width or normal character code.
If double width character has been set by the SO command, the same function as the US
command will be assumed.
RS, US, SO
iDP-460 User's Manual
ALL