Citizen iDP-460 User Manual page 50

BELL (D-type Only)
[Name]
[Code]
[Function]
[Caution]
ESC a (n) ;
[Name]
[Code]
[Domain]
[Function]
[Caution]
[Initial Value]
[Sample Program]
ESC b (n) ;
[Name]
Drawer kickout
<07>H
This command outputs a designation signal to the connected drawer interface. The signal
is about 200 ms. Designation is made when the solenoid is connected. The command
functions even if not connected to the drawer interface, but it is meaningless.
Connect only what is specified to the drawer interface. Otherwise, when this function is
activated, the main body or mating connection element may have a trouble or be
destroyed. While this command is functioning, the printer is stopping. Do not specify
this command continuously. It could cause a trouble.
Set Line Height
<1B>H<61H>(n)<3B>H
7 ≤ (n)≤ 255 (<30>H ≤ n ≤ <39>H)
This command defines a height of each print line. A dot line is 1/18 inch. It sets a line
feed rate to (n-1)/3/18 inch.
A parameter(n) is 7 to 255. If this value is 10, there will be 6 lines per inch. A minimum
value of 7 assumes about 9 lines per inch, allowing no space between each line. The line
is fed in the set condition until re-setting or initialization(ESC c) is made. The initial
condition is restored with "ESC a 10; 1" or an initialization command.
Be sure to add ";"(<3B>H) to the end of the parameter.
A line height for normal characters is 1/6 inch.[(n) = 10]
When setting the line height to n = 20(1/3 inch)
ESC a 20 ; → LPRINT CHR$(&H1B)+"a20;";
<1B>H<61>H<32>H<30>H<3B>H
Eject Paper by n-lines
iDP-460 User's Manual
ALL
ALL
ALL