Rudder Function - Fly Sky FS-i10 Instruction Manual

Digital proportional radio control system

22.08 Rudder function

Function Details:
Rudder function is used to adjust the proportion of the 2 rudders end points and the defaults are
100%.There is no function if the airplane does not have the rudder or 2 rudder linkage. The function
icon will not be shown on the screen. This function can be set in 5 conditions respectively.
Select the desired "Down" or "Up" and move the wheel to adjust the corresponding value.
For this example: The airplane has 2 rudders. Adjust two rudders' value as picture 22.11. In this
situation, the rudder end points will be 80% and 75% .
22.09V-tail
Function Details:
This function is used to control elevator and rudder of models with V-tails. CH2
is a left V-tail by default and CH4 is right V-tail . When both V-tails move in the
same direction ,they act as elevators and when both V-tails move in the opposite
direction. This function lets users adjust for left and right rudder angle changes at
elevator and rudder operation of a V-tail airplane. V-tail is when 2 servos are used
together to control rudder movement as Elevators. In addition to each rudder
side moving up and down together, each side moves in opposite directions when
moving as Elevators. It is better that the sum of the rudder proportion and elevator
proportion is no more than 100%. The defaults are 50%. The position of the
corresponding channel displays in real time while moving the stick.
Select the elevator rate or rudder rate to set and move the wheel to adjust the
corresponding value.
For this example: The airplane structure with the V-tail, will adjust the value as
shown in pictures 22.12 and 22.13. Move the rudder stick to the far left, then CH2
channel displays at the position of 40 on the right. On the contrary, move the rudder
stick to the far right, then CH4 displays at the position of 40 on the left. Moving the
elevator stick to the topside or the bottom, both of the Ch2 and CH4 display at the
position of 60 on the right or on the left at the same time, then the elevator function.
22.10. Airplane structure
Function Details:
This function can be set according to the airplane
structure.



There are engine, throttle needle, aileron, two aileron,
flap, two flap, sopliler, two spoliler, rudder, two rudder,
V-tail to choose if the mode type is fix wing or glider. There
will be a reminder "Maximum number of channels
reached." if the airplane parts selected is more than 10.
Because the two rudders and V-tail can not exist at the
same time, the V-tail will be hidden automatically when two
rudders is selected. The default type is Fix wing/glider with
engine, aileron, elevator and rudder.
The rudder to the far left The elevator stick to the
(Pic 22.12)
(Pic 22.14) (Pic 22.15)
Maximum number
airplane list
of channels reached
(Pic 22.11)
(Pic 22.13)
topside.
(Pic 22.16)
Default airplane/glider type
5 51