Table of Contents
Advertisement
21.
General function menu
21.01. Reverse
Function Details
This function enables the user to modify the direction of operation of each ot the ten servos. For each
channel the user can toggle a reverse state based on demand
The reverse function individually reverses the direction of operation of the servos on the 10 channels.
This menu contains 10 check boxes, one for each channel. To toggle the reverse state of a channel,
just touch it.
As shown in the picture 21.1, only the third channel is reversed, the other channels operate normally.
! Always complete your servo reversing prior to any other programming. If mix functions
control multiple servos, it may be confusing to tell whether the servo needs to be reversed or
a setting in the function needs to be reversed.
! Always check servo directions prior to make sure they are in the same way with operation
direction. If not, please adjust to right direction.
21.02. End points
Function Details:
This function enables the user to control the low and high travel limits for each servo. For each channel
the user can set the low and high limits. This ensures that the channel data for the servo is consistent
with structural design and performance requirements to ensure the best results. Adjustments can be
made for any channel
The end points function individually adjusts the low and high travel limit of each servo on the 10
channels. Set the end points according to your airplane structure.
To choose the side of one channel end point to set, move the stick to the desired low or high
side or just touch the corresponding button. The selected side will be highlighted in yellow. The red
needle represents the selected side. Use the wheel to move it and modify the end point value. The
position of the corresponding channel is displayed in real time.
As shown in the picture 21.2, the acceleration side of the elevator is selected and the elevator trigger
is half accelerating.
21.03. Subtrim
Function Details:
This function enables the user to control the structure and angle difference for each channel on the
servo. This allows the user to make adjustments to get the best results for their system
The subtrims function individually adjusts the center position of each servo of the 10 channels. This
is particularly useful when the servo mechanics doesn't allow an adjustment fine enough.
Touch the channel which subtrim must be adjusted. Use the wheel to move the red needle and modify
the subtrim value of the selected channel. The position of the corresponding channel is displayed in real
time
As shown in the picture 21.3, the channel 1 has been selected and the red needle is at the position of
50% .
20
28
Ch2 stick to the far right
http://www.flysky-cn.com
(Pic 21.1)
(Pic 21.2)
(Pic 21.3)
Hide quick links:
Advertisement
Table of Contents
