Rpm Telemetry Module Setup - Fly Sky FS-i10 Instruction Manual

12.03
i-bus Receiver Connection instruction Setup
FS-AEV01
Function Details ：
The system is able to support many channels. This allows the user of the system to change to a different
output channel should signal strength be insufficient
i-BUS receiver, can connect 4 modules with 16 channels in serial at most. Button K1 and K4 correspond to C1 and C4
respectively.
Operation instruction:
1. FS-AEV01 i-BUS The "IN" port of FS-AEV01 receiver corresponds to "OUT" port of receiver.
2. FS-AEV01 i-BUS The "OUT" port of FS-AEV01 receiver is used to connect post level FS-AEV01 receiver.
3. Insert the bus receiver to receiver, and then switch on the matched transmitter and receiver. The LED will be on.
4. Select main menu of receiver setup to enter the interface of servo setup.
5. Select channel which need to be expanded, meanwhile LED of bus receiver is off.
6. Push relevant channel button by plastic needle of matching line. The setup is successful if LED flashes automatically.
7. Insert servo to check.
8. Set up 4 channels of bus receiver as above steps.
9. Just connect a new bus receiver with "OUT" port of first stage bus receiver if more channel needed. Set up the new one as
above steps.
Notice: When the load of serial bus receiver is excessive and electric current is higher than usual, please supply power
directly to the serial bus receiver or it will break cables.
12. RPM telemetry (magnetic) module setup
04 FS-APD01
Function Details ：
This function allows the user to monitor turning speed via the transmitter. This is a
very useful function when determination of turning speed is required
Operation:
1. Insert one end of standard 3 PIN plug into "OUT" port of RPM telemetry (magnetic)
module, and insert the other end into "IN" port of receiver or other sensor, as shown
in the picture 12.4.
2. As shown in the picture 12.5: Inside hub of the model, the distance between sensor
and magnet is less than2mm. The North Pole or the south pole of the magnet has
to be paralleled with sensor.
3. Switch on transmitter and receiver. "Motor speed 2:0RPM" will be shown in receiver
window in display screen. Speed value changes as turning wheel, which means
installation is successful.
16
(Pic 12.3)
(Pic 12.4)
(Pic 12.5)
http://www.flysky-cn.com
Sensor
Revolving
speed module
Magnet
Gear
15