Rx Setup - Fly Sky FS-i10 Instruction Manual

Digital proportional radio control system
Hide thumbs Also See for FS-i10:
Table of Contents

Advertisement

Setting model type:
All the model settings must be reset to default state of airplane or glider, then
enter 'structure setting'. The default structure of airplane or glider is 4
channels (throttle, aileron, elevator and rudder), the structure can be changed
by touching the check box. The default structure of helicopter is fixed pitch; it
can be changed to variable pitch by touching check box. At the same time, the
swash plate type can be set
As shown in picture 21.44, modifies the structure of Flysky01, touch "setting
model type", after selecting the airplane or glider type, the Flysky01 will reset
to default state. Select throttle needle, two ailerons, two flaps, and then touch
back key. The modified structure will be as shown in picture 21.45

21.25 RX setup

Function Details:
Set up the receiver. This function is used to set the corresponding
parameter of the receiver and the sensors connected. RX setup menu.
(As shown in picture 21.46)
Bind with a receiver: The transmitter enters in bind mode. Once the
receiver is correctly bound, press the back button to return to normal
operation. (As shown in picture 21.48)
AFHDS2: the default is a 2-WAY AFHDS2A communication system.
AFHDS, AFHDS2,1-way AFHDS2A, and 2-WAY AFHDS2A.Users can
select the required system based on the receiver type
RX battery monitor: Monitors the receiver battery voltage.
External sensor: Do not monitor the receiver power supply voltage
but use an external sensor instead. This is useful when the receiver is
powered by an ESC. Connect the external sensor directly to the main
battery. (Asshowninthepicture 21.47)
Low voltage: set the minimum voltage when the battery is almost
empty. default low voltage value is 4.00V.
Alarm voltage: set the voltage under which an audible alarm rings
and the receiver battery icon in the top tray blinks. (As shown in the
picture 21.49)
High voltage: set the maximum voltage when the battery is full.
default high voltage value is 5.00V.
40
(Pic 21.44)
(Pic 21.46)
(Pic 21.48)
http://www.flysky-cn.com
(Pic 21.45)
(Pic 21.47)
(Pic 21.49)

Advertisement

Table of Contents
loading

Table of Contents