Table of Contents
Advertisement
22.
Airplane/glider exclusive function menu
22.01 Aileron function
Function Details :
This function is used to adjust aileron function of models and give it best control.
Aileron function can be used to adjust the proportion of the 2 ailerons end points. If the structure does not
have the aileron, 2 aileron linkage, flap or elevator, then there is no this function, and no icon will be displayed.
It also can be used as aileron function if the airplane structure has 2 flaps or elevators, meanwhile the
corresponding value be adjusted exceed 0%. This function can be set in 5 conditions respectively.
Select desired upside or downside and move the wheel to modify the corresponding value.
For this example: The airplane structure has 2 ailerons, 2 flap and 2 elevator. Setting the value as the
picture 22.1, in this situation, the end points of the two ailerons are 80%, and the 2 flaps and 2 elevators are
regarded as aileron function, which the end points both are 10%.
22.02. Flap function
Function Details :
This function is not available when aircraft structure has aileron, flap or only one elevator or less than one elevator,
so there is no icon in the main menu. If aircraft has more than 2 ailerons, flaps and elevators, this function exist
The up/down travel of each flap can be adjusted independently at each servo according to the wing type. If the
structure does not have an aileron, 2 ailerons linkage, flap or elevator, then this function is not available, and no
icon will be displayed. It can be used as flap function. if the airplane structure has 2 ailerons, the corresponding
value must be adjusted to more than 0%, The flap function can be assigned to a switch (SwA-SwH) to enable and
disable it; it also can be assigned to a stick or a knob (Ail, Ele, Thro, Rud, VRA-VRE) to adjust the value. This
function can be set in 5 conditions respectively.
Select desired upside or downside and move the wheel to modify the corresponding value.
For this example: The airplane structure has 2 flaps and 2 ailerons. Setting the value as the picture, in this
situation 22.2, the end points of the two flaps are 80% and the 2 ailerons are regarded as flap function, which
the end points are all 10%.
22.03 Spoiler function
Function Details:
Spoiler will be used when aircraft is landing. It is used to increase pressure between aircraft and land so as to
brake quickly
Spoiler function can be used to adjust the proportion of the 2 spoilers' end points. If the structure does not
have spoiler or 2 spoiler linkage, then there is no this function, and no icon will be displayed. The spoiler
function can be assigned to a switch (SwA-SwH) to enable and disable it, or be assigned to a stick or a knob
( Ail, Ele, Thro, Rud, VRA-VRE) to adjust the value. This function can be set in 5 conditions respectively.
Select desired upside or downside and move the wheel to modify the corresponding value.
For this example: The airplane structure has 2 spoilers. Setting the value as the picture 22.3, in this situation,
the end points of the 2 spoilers are 80% and 75%.
48
http://www.flysky-cn.com
(Pic 22.1)
(Pic 22.2)
(Pic 22.3)
Hide quick links:
Advertisement
Table of Contents
