Module Transformation - Fly Sky FS-i10 Instruction Manual

Digital proportional radio control system
10.11.

Module transformation

When you want to connect A series module with C series module,
you need to use a A-C patch cord.
When you want to connect C series module with A series module,
you need to use a C-A patch cord.
C series modules than A series module performance superior.
C
11.
Receiver and servo connections
In order to make sure maximum distance between the transmitter and receive can be obtained please follow the
directions below:
1. The two antennas must be kept as straight as possible. Otherwise, control range will be reduced.
2. The two antennas should be placed at a 90 degree angle to each other, as illustrated in the three pictures below.
3. The antennas must be kept away from conductive materials, such as metal and carbon. A distance of at least 15 cm
is required for safe operation. Conductive materials will not affect the coaxial part of the antenna, but it is important
that the coaxials are not bent to a severe radius.
4. Keep antennas away from the motor, speed controller and other noise souces as much as possible.
(26mm)
Coaxial cable
( Pic 11.1 )
Antenna
A
C
A
Receiver
( Pic 11.2 )
A
A
Receiver
Receiver
( Pic 11.3 )
Antenna
C C
5 13