Throttle Down - Fly Sky FS-i10 Instruction Manual

21.10. Throttle Down

Function Details:
This function contains two options: option one is idle setup and option two is throttle hold Two
options would be set when you adjust models. The idle is useful for the models with engines and make
models keep low rpm without shutting down. And the throttle hold is to completely lock model's throttle
without shutting down.
Throttle down function is to enable idle down rate adjustment and throttle cut function turned on
or off. Modify the rate from 0% to 50% after idle function is applied. This function can be set in five
conditions.
Idle down: the throttle output minus the rate set in advance after this function is applied.
Throttle cut: the throttle output will be in its lowest point after this function is applied.
Throttle cut function is prior to idle down function. There is no output while moving throttle stick
if throttle cut function is applied. Idle down function and throttle cut function are turned off by
default. The default value of idle down is 10%.
These two functions can be assigned to 2 switches (SwA~SwH、LSw). If the airplane does not
have an engine, this icon will not be displayed.
Select two switches to enable or disable idle down and throttle cut function and move the wheel
to modify the corresponding value after activating this function.
As shown in the picture21.12: The idle down function and throttle cut are applied, and adjust
the idle down to 20%. There is no output of throttle channel.
21.11. Auxiliary Channels
Function Details :
The model function allows users to set additional auxilary channels if the
model has more than the default 4 channels. Some aircraft have more than
four auxilary channels, so these additional channels can be modified using
this function.
Assign the auxiliary channel a switch, a knob, a logic switch or a stick
after finishing the airplane structure setting. The default structure is 4-channel
fix wing, so auxiliary channels are from Ch5 to Ch10.
Touch the auxiliary channel needed and select a switch, a knob, a logic
switch or a stick to control this function.
For this example: Select CH5 as auxiliary channel and push SwD upward
to enable this function. At this time, the channel in Servo display is displayed
as shown in picture 21.14
32
(Pic 21.13)
Push swd downward
http://www.flysky-cn.com
(Pic 21.12)
(Pic 21.14)