Manual - Tunturi Platinum PRO User Manual

Workout screen
The X-axis unit is shown according to
the selection of Energy/Time/Distance in
Set screen:
Energy Unit:
Time Unit:
Distance Unit:
• During workout, press the jogwheel
button to switch the Y-axis between
W↔ bpm
• Turning the jogwheel will increase/
decrease the Target HR level in Bpm
• The bar chart denotes target heart rate
value bpm. Rotate the jogwheel to adjust
the target heart rate value.
• The white dot line shows current
position, which moves rightward as
calorie /time/distance increases.
• The orange curve shows the user's
actual heart rate, which varies as the
heart rate frequency goes up and down.
• The blue curve shows the actual Watt
value.
• Console programming: Assist the user to
achieve the target according to its target
heart rate input during workout. When
actual heart rate is higher than target
value, the system would decrease Watt
value; while increases Watt value when
actual heart rate is below target value.
• A message of "No Heart Rate" is shown
if the user's heart rate is not detected
during workout.
To stop your workout see:
"End your workout"
10
kcal
min
km in metric
mile in Imperial

Manual

• Turn the jogwheel and select
"Manual"
• press the jogwheel to confirm and
enter the Setting screen (1).
Setting screen (1)
• Turn jogwheel to select item
• Press the jogwheel button for
confirmation and continue the range
setting at the right.
• Turn jogwheel to change setting ranges
• Press the jogwheel button to confirm and
enter the Workout screen.
Workout screen
The X-axis unit is shown according to
the selection of Energy/Time/Distance in
Set screen.
Energy Unit:
Time Unit: min
Distance Unit: km in metric
mile in Imperial
• During workout, press the jogwheel
button to switch the Y-axis between
Nm↔ bpm
kcal