Gas Conversion Kits - Superior DRT4040DMN Installation And Operation Instruction Manual

Innovative Hearth Products
Superior DRT40 Direct Vent Gas Fireplace
TM

GAS CONVERSION KITS

This conversion kit shall be installed by a qualified service agency in accor-
dance with the manufacturer's instructions and all applicable codes and
requirements of the authority having jurisdiction. If the information in these
instruction is not followed exactly, a fire, explosion or production of carbon
monoxide may result causing property damage, personal injury or loss of
life. The qualified service agency is responsible for the proper installation
of this kit. The installation is not proper and complete until the operation
of the converted appliance is checked as specified in the manufacturer's
instructions supplied with the kit.The qualified service agency performing
this installation assumes responsibility for this conversion.
Cette trousse de conversion doit être installée par un technicien agréé,
selon les instructions du fabricant et selon toutes les exigences et tous les
codes pertinents de l'autorité compétente. Assurez-vous de bien suivre
les instructions dans cette notice pour réduire au minimum le risque
d'incendie, d'explosion ou la production de monoxyde de carbone pouvant
causer des dommages matériels, des blessures ou la mort. Le tecnicien
agréé est responsable de l'installation de cette trousse. L'installation n'est
pas adéquate ni complète tant que le bon fonctionnement de l'appareil
converti n'a pas été vérifié selon les instructions du fabricant fournies avec
la trousse. Le fournisseur de service qualifié ayant réalisé l'installation
assume les responsabilités liées à la conversion.
In Canada:
THE CONVERSION SHALL BE CAR-
RIED OUT IN ACCORDANCE WITH THE
REQUIREMENTS OF THE PROVINCIAL
AUTHORITIES HAVING JURISDICTION
AND IN ACCORDANCE WITH THE RE-
QUIREMENTS OF THE CAN/CGA-B149.1
INSTALLATION CODE.
LA CONVERSION DEVRA ÊTRE EF-
FECTUÉE CONFORMÉMENT AUX RE-
COMMANDATIONS DES AUTORITÉS
PROVINCIALES AYANT JURIDICTION ET
CONFORMÉMENT AUX EXIGENCES DU
CODE D'INSTALLATION CAN/CGA-B149.1.
Gas conversion kits are available to adapt your
appliance from the use of one type of gas to
the use of another. These kits contain all the
necessary components needed to complete the
task including labeling that must be affixed to
ensure safe operation.
Kit part numbers are listed here and the follow-
ing steps detail the conversion procedure. Refer
to the instructions provided with the conversion
kit when performing any gas conversion.
36
WARNING
AVERTISSEMENT
Millivolt SIT Systems
Natural Gas To Propane Gas
Conversion Kits
Models
40" Model
45" Model
Millivolt SIT Systems
Propane Gas to Natural Gas
Conversion Kits
Models
40" Model
45" Model
Electronic SIT Systems
Natural Gas To Propane Gas
Conversion Kits
Models
40" Model
45" Model
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Models
40" Model
45" Model
INSTALLATION INSTRUCTIONS
Step 1. TURN OFF THE GAS SUPPLY TO THE
APPLIANCE and disconnect power supply at
the circuit breaker. Ensure appliance is cold.
CAUTION: THE GAS SUPPLY SHALL BE
SHUT OFF PRIOR TO DISCONNECTING THE
ELECTRICAL POWER, BEFORE PROCEED-
ING WITH THE CONVERSION.
ATTENTION: AVANT D'EFFECTUER
LA CONVERSION, COUPEZ D'ABORD
L'ALIMENTATION EN GAZ, ENSUITE,
COUPEZ L'ALIMENTATION ÉLECTRIQUE.
Step 2. Open the bottom drop-down door. Open
it (see Figure 51 on Page 26) by pushing in
simultaneously the left and right top corners
of the door. (The door is hinged at the bottom).
Remove the bottom compartment door by
sliding the hinge pin, located at the door's left
side, to the right until it disengages from the
left corner post hole. Pull the door diagonally
to the left, away from the fireplace.
Step 3. Remove the front glass door/frame from
Catalog No.
the appliance (see instructions on Page 30).
85L63
85L64
Step 4. Carefully remove the logs. Exercise
care so as not to break the logs.
Step 5. Refer to Figure 63.
A. Above the burner, remove the two baffle
securing screws. Remove the baffle.
Catalog No.
B. Remove the two screws securing the trap-
85L70
ezoidal plate to the burner. Remove the plate.
85L71
C. Remove the burner assembly with attached
venturi tube.
Catalog No.
H9101
H9102
Installation and Operation Instructions
900357-00, 06/2015
Electronic SIT Systems
Propane Gas To Natural Gas
Conversion Kits
Catalog No.
H9104
H9105