Front Glass Enclosure Panel, Barrier, Removal And Installation - Superior DRT4040DMN Installation And Operation Instruction Manual

Innovative Hearth Products
Superior DRT40 Direct Vent Gas Fireplace
TM
Front Glass Enclosure Panel, Removal
and Installation
WARNING
• Do not attempt to substitute the
materials used on these doors,
or replace cracked or broken
glass.
• Handle this glass with extreme
care! Glass is susceptible to
damage - Do not scratch or
handle roughly while reinstall-
ing the glass door frame.
• The glass door(s) of this appli-
ance must only be replaced as
a complete unit as provided
by the manufacturer. Do not
attempt to replace broken,
cracked or chipped glass sepa-
rately.
• Do not attempt to touch the
front enclosure glass with your
hands while the fireplace is in
use.
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou
brisé.
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l'entretien de
l'appareil doit être remis en
place avant de mettre l'appareil
en marche.
Only doors certified with the appliance
shall be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
WARNING: DO NOT abuse glass door by
striking or slamming shut.
Removing Glass Enclosure Panel
(see Figure 70)
To access the glass door securing latches, first
remove the hood by pulling firmly straight away
from the unit. Remove the front face assembly
by lifting top and bottom evenly approximately
1/2" and pulling straight out from the unit once
the brackets are disengaged.
If needed, remove the bottom compartment
door by sliding the hinge pin, located at the
door's left side, to the right until it disengages
from the left corner post hole. Pull the door
diagonally to the left, away from the fireplace.
Locate the two (2) glass door spring latches at
the top of the control compartment (see Figure
70). Pull out each spring latch until it disengages
from the door frame bottom vee-flange. Remove
the door by tilting it outward at the bottom and
lifting it up. Set the door aside, taking care to
protect it from inadvertent damage.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installation and Operation Instructions
900357-00, 06/2015
Installing Glass Enclosure Panel
(see Figure 70)
Retrieve the glass door. Visually inspect the
gasket on the backside of the frame. Gasket
surface must be clean, free of irregularities
and seated firmly.
Position the door in front of the firebox opening
with the bottom of the door held away from the
fireplace (Figure 70). Hook the top flange of the
door frame over the top of the firebox frame.
Let the bottom of the door frame swing gently
in towards the fireplace ensuring that the gasket
seats evenly as the door frame draws shut. Fas-
ten the two spring latches located underneath
the firebox floor to the door's vee-flange.
NOTE: Front Face Assembly with
barrier installed must be rein-
stalled prior to operation.
Top Flange
Glass Door Frame
Glass Door
Bottom Vee-flange
Glass Door Frame Firebox Floor
Glass Door
Spring Latch
Figure 70
45