Gas Conversion Kits - Superior VRE3236ZENWS Installation And Operation Instructions Manual

GAS CONVERSION KITS

Gas conversion kits are available to adapt your
appliance from the use of one type of gas to
the use of another. These kits contain all the
necessary components needed to complete the
task including labeling that must be affixed to
ensure safe operation.
Kit part numbers are listed here:
Natural to Propane Gas Conversion Kits
Cat. # Model
F4126 CKAF4004SLLXNP
Propane to Natural Gas Conversion Kits
Cat. # Model
F4127 CKAF4004SLLXPN
Table 7
See the following Table for orifice sizes for
natural and propane models. Figure 26 illus-
trates the orifice. Use pipe joint compound or
Teflon tape on all pipe fittings before installing
(ensure propane resistant compounds are used
in propane applications, do not use pipe joint
compounds on flare fittings).
Burner Orifice Sizes
Elevation 0-4500 feet ( 0-1372 meters)
Nat.Gas
Model
drill size (inches)
VRE3236 3.25mm (.128")
VRE3242 3.25mm (.128")
Table 8
Figure 26
16
This conversion kit shall be installed by a qualified service agency in
accordance with the manufacturer's instructions and all applicable codes
and requirements of the authority having jurisdiction. If the information in
these instruction is not followed exactly, a fire, explosion or production of
carbon monoxide may result causing property damage, personal injury
or loss of life. The qualified service agency is responsible for the proper
installation of this kit. The installation is not proper and complete until the
operation of the converted appliance is checked as specified in the manu-
Fireplace
facturer's instructions supplied with the kit. The qualified service agency
VRE32 36/42
performing this installation assumes responsibility for this conversion.
Fireplace
VRE32 36/42
Cette trousse de conversion doit être installée par un technicien agréé,
selon les instructions du fabricant et selon toutes les exigences et tous les
codes pertinents de l'autorité compétente. Assurez-vous de bien suivre
les instructions dans cette notice pour réduire au minimum le risque
d'incendie, d'explosion ou la production de monoxyde de carbone pouvant
causer des dommages matériels, des blessures ou la mort. Le tecnicien
agréé est responsable de l'installation de cette trousse. L'installation n'est
pas adéquate ni complète tant que le bon fonctionnement de l'appareil
converti n'a pas été vérifié selon les instructions du fabricant fournies avec
la trousse. Le fournisseur de service qualifié ayant réalisé l'installation
Propane
assume les responsabilités liées à la conversion.
drill size (inches)
#49 (.073")
In Canada:
#49 (.073")
THE CONVERSION SHALL BE CARRIED OUT IN ACCORDANCE WITH THE REQUIREMENTS
OF THE PROVINCIAL AUTHORITIES HAVING JURISDICTION AND IN ACCORDANCE WITH THE
REQUIREMENTS OF THE CAN/CGA-B149.1 AND .2 INSTALLATION CODE.
LA CONVERSION DEVRA ÊTRE EFFECTUÉE CONFORMÉMENT AUX RECOMMANDATIONS DES
AUTORITÉS PROVINCIALES AYANT JURIDICTION ET CONFORMÉMENT AUX EXIGENCES DU
CODE D'INSTALLATION CAN/CGA-B149.1 ET .2.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
WARNING
AVERTISSEMENT