Table of Contents
Advertisement
SENSITIVITY: Each channel has a corresponding sensitivity setting, with the 4 levels of 1, 2, 3 and 4, in which 4 is the highest.
Press "Enter" for changeover.
MD AREA: Each channel has a corresponding motion detection area setting. Move the cursor to "Setup" of the corresponding
channel, and press "Enter" to enter the motion area setup screen of this channel, where a red block indicates motion detection is
activated for this area and a transparent block indicates motion detection is not activated, as shown below:
Operating prompt:
Remote controller operation: Use " " (display mode) to select full screen or blank;
Mouse operation: Left-click the mouse and drag the motion box to set the area of dynamic detection.
Motion detection setup procedures:
A.
Turn "On" the corresponding channel in the "Channel Switch" option;
B.
Set the sensitivity level as necessary, usually set at 3 or 4;
C.
Set the motion area of the corresponding channel in the "Area Setup" option;
D.
In the "Recording Mode" screen, set the corresponding channel to "On" in the "Channel" option;
E.
In the "Recording Mode" screen, select "Timing Recording" in the "Recording Mode" option, also click "Record Time
Configuration" to enter the Record Time Configuration screen and set the corresponding time to alarm recording (see timing
recording in "Recording Mode" for the setup method).
After the setup has been done and motion detection triggered, a red letter "M" will appear in the screen of this channel. See "Alarm
processing" in Section 3.6.1 for alarm processing.
3.7.4 Mobile phone monitoring
The mobile phone monitoring function of this series DVR is supported by mobile phones of the Windows Mobile and Symbian
operating systems, such as Dopod P660, Nokia N78 and Nokia N97.
The operating procedures are as follows:
Setup method of mobile phone monitoring at the DVR host:
Enter the following screen from "Main Menu" →"Advanced Functions" →"Mobile Phone Monitoring":
Set cell phone login user name and password, defaults are empty.
Service port: with a setting range of 1,024—65,535; this port has to be mapped on the router, and its setup method is the same
as the mapping method of the port in network setup.
18
Advertisement
Table of Contents
