Advanced - Watchguard DVR4EONPACK Manual

Note: The system will restart when the VGA resolution or the camera resolution is modified.

3.7 Advanced

Enter the following screen from "Main Menu" →"Advanced":
The advanced functions include the 7 options of alarm setup, system information, motion detection, mobile phone monitoring,
system maintenance, PTZ Setup and Network Setup.
3.7.1 Alarm
Move the cursor to the "Alarm" option (the icon is surrounded by a yellow frame to indicate selection), and press "Enter" to enter
the setup screen of this option, as shown below:
HDD LOSS: On: When the system cannot identify the harddisk, an alarm will be generated, and a red mark "H" will be displayed at
the bottom left corner of Channel 1 in the lower part of the Video Preview screen.
HDD SPACE: On: When the remaining space of the harddisk is less than 500M, the lower part of the Video Preview screen will
display: "The space of the harddisk is not enough. Please change the disk after shutdown."
VIDEO LOSS: On: When the video of a certain channel is lost, this channel will display in the lower part of the Video Preview
screen: "Video Loss".
ALARM MANAGE BUZZER: the time of buzzer ringing when an alarm is generated, with the options of 0sec, 10sec, 20sec, 40sec
and 60sec
Post Alarm Recording: the time of record delay after the motion detection alarm, with the options of 30sec, 1min, 2min and 5min
Email SETUP: This unit supports motion detection and e-mail alarm.
Email setup Prerequisite: The mainframe must be connected to the WAN. See Chapter 4 "DVR Network" for the connection
method.
When motion detection is triggered, the system will extract a picture at the time of triggering and send it to the corresponding
mailbox. The size of the extracted picture is about 11K.
16