Configuring Print Engine Settings (Fingerprint Only); Configuring Web Shell Settings - Intermec PD41 Manual

Chapter 3 — Configuring the Printer
44
2 Enter the correct information for the media you are using.
3 Click Submit Setup.

Configuring Print Engine Settings (Fingerprint only)

Use the print engine page to adjust the media feed direction (start and
stop adjust positions) and print speed. The value of the head
resistance is read-only and is measured by the firmware when the
printer starts up.
To configure print engine settings
1 Click Printer > Print Engine.
2 Enter the correct information for the print engine.
3 Click Submit Setup.

Configuring Web Shell Settings

Use the Web Shell page to view and change test and default settings.
You can also use the Web Shell page to print test labels and change the
command language.
To configure Web Shell settings
1 Click Printer > Web Shell.
2 Select the action you want to take or the setting you want to
change.
• For the actions in the top of the screen, the printer performs
the action and may prompt you to reboot the printer.
For the settings in the bottom of the screen, select your desired
•
settings and click Submit Setup. You will receive a message
that reads "Application change will take effect at reboot." You
can choose to select Reboot or wait until you are done making
other configuration changes.
PD41 and PD42 Commercial Printer User's Manual