Configuring Tcp/Ip Settings - Intermec PD41 Manual

Chapter 3 — Configuring the Printer
50
Use the following table to understand SNMP settings.
Understanding the SNMP Settings
Setting
Read Community
Read/Write
Community
Username
Authentication Key
Encryption Key
System Name
Authentication Failure
Trap
Trap Address Settings Click Add to specify these trap address settings:

Configuring TCP/IP Settings

Use the TCP/IP settings page to view and change TCP/IP network
settings.
To configure TCP/IP settings
1 Click Network Admin > TCP/IP.
2 View or update your settings.
3 Click Submit TPC/IP settings.
Description
Community with rights to read the SNMP MIBs.
Community with rights to read and write SNMP
MIBs.
Username when using SNMPv3. The default value
is "initial".
The authentication key for SNMPv3. The default
value is "auth_key".
The privacy key for SNMPv3. The default value is
"priv_key".
Administrative name for the SNMP node.
Defines if a trap is sent when an unauthorized
SNMP request tries to access the printer. Choose
Enable to send the trap.
•
Trap Address: IP address of the receiver of
SNMP traps. You can specify up to four trap
addresses.
•
Trap Port: The port where SNMP traps are sent.
The default port if 162.
•
Trap Community: Defines the community to
which SNMP traps will be sent.
•
Friendly Name: A user-defined text string that
identifies the trap.
•
Trap Enable Status: Defines whether the
specified trap is enabled.
PD41 and PD42 Commercial Printer User's Manual