Configuring The Printer; Configuring The Pd42 Printer From The Screen - Intermec PD41 Manual

Chapter 3 — Configuring the Printer

Configuring the Printer

Configuring the PD42 Printer from the Screen

40
You can change the configuration settings of your printer:
• directly from the screen.
• from the printer home page.
• using PrintSet.
• using commands sent from your PC.
• using SmartSystems Foundation.
To configure the PD42 printer from the screen, you need to enter
Setup mode.
To enter Setup mode
• Press the button.
While in Setup mode, use the soft keys to navigate. For help using the
soft keys, see "Understanding the PD42 Screen and Soft Keys" on
page 7.
Use the following illustrations to understand the Setup menu. The
main nodes of the setup tree are organized in a loop. You can view
detailed illustrations of each menu in Appendix C
and ESim Setup Menus" on page
out to a number of sub-nodes. At startup, the firmware determines if
optional equipment such as a cutter or an interface board is installed
in the printer, and these are added to the Setup tree.
119. Each main node branches
PD41 and PD42 Commercial Printer User's Manual
"Fingerprint, IPL,