Disassembly And Reassembly - Xerox WorkCentre XK50cx Service Manual

3. Disassembly and Reassembly

3-1 General Precautions on Disassembly
When you disassemble and reassemble components, you must use extreme caution. The close proximity of
cables to moving parts makes proper routing a must. If components are removed or replaced, any cables
disturbed by the procedure must be replaced as close as possible to their original positions. Before removing
any component from the machine, note the cable routing that will be affected.
Whenever servicing the machine, you must perform as follows:
1. Check to verify that documents are not stored in memory.
2. Unplug the power cord.
3. Use a flat and clean surface.
4. Replace only with authorized components.
5. Do not force to remove or planten plastic-material components.
6. Make sure all components are in their proper position.
3-2 White Roller
1. Lift the ADF unit
2. Push the bushing on both ends of the roller
slightly inward, then rotate it until it reaches
the slot. Then lift the the roller out.
3-1