Table of Contents
Advertisement
5-5-3-2
SYSTEM DATA
MODEM SPEED
Default = 33600 bps
Select baud rate of 33600, 28800, 14400, 12000, 9600,
7200, 4800, or 2400 bps. The lower the baud rate, the
larger the acceptable error rate. T30 protocol has a
fixed speed of 300 bps in the protocol mode. When
the TX speed is set to 33600 or 28800 bps, the RX
speed will be either V.17 or V.34.
When the TX speed is set to 14400 or 12000 bps, the
TX speed will be either V.17 or V.33. When the TX
speed is set to 9600 or 7200 bps, the RX speed will
be either V.29 or V.27 ter. When the TX speed is set
to 4800 or 2400 bps, the RX speed will be V.27 ter.
FAX TX LEVEL
Default = -12 dBm
FCC requires that the transmission level be less than
-9 dBm. from -9 dBm to -15 dBm is acceptable.
You can set the transmission level between - and -15
dBm in 1 dBm steps using the control panel keypad.
Accuracy is +0/-3 dBm.
FAX RX LEVEL
Default = -43 dBm
Reception level may be too low due to cable losses.
If set to -43 dBm, reception sensitivity will be
between 0 and -43 dBm.
PAUSE TIME
Default = 3.0 seconds
This sets the length of the pause time from 1
through 9 seconds, when the pause button is
pressed.
ERROR RATE
Default = 5%
Error rate of "RTN send" during transmission.
MAKE BREAK RATIO
Default = 40/60
DP dial
CNG DETECT CNT
Default = 2 times
After detecting the chosen CNG Tone, Ans/Fax
Mode (1 to 4 times)
AUTO DIAL TIME OUT
Default = 55 seconds
T1 Time out default opting during transmission
(possible to choose between 30 to 70)
DIAL MODE LOCATION
Default = User Mode
Use Dial Mode Option to change between User
Mode or Tech Mode.(User/Tech)
5-5-3-3. CHANGING SYSTEM DATA
Press MENU and when "MENU 01 [System Data]"
message displayed on the LCD then press start or
select.
When the desired system data appears, enter the
corresponding information to change the status of
the selected function. Press STOP to return to the
date and time display.
Troubleshooting
5-11
Advertisement
Chapters
Table of Contents
