Furuno FSV-85 Operator's Manual page 138

7. OTHERS MENU
H2/S Display: Selects the combination mode of horizontal and slant displays: Land-
scape, Portrait, or Inset.
2nd Monitor Setting: When two monitors are connected, select the combination
mode for the sub-display; Landscape or Portrait. This function is available only when
[Dual Display] is selected at [2nd Monitor Setting] on [Others]-[Initial Setting] menu.
V-Scan Aspect Ratio: Selects the type of the horizontal to vertical ratio to use on the
V-display; Fixed or Flexible.
V-Scan Dept Rng: Selects the ratio to shrink the display range in the vertical direction.
This item is available only when [Flexible] is selected at [V-Scan Aspect Ratio] in
above.
Presentation Mode: Selects presentation mode. Head-up, North-up, Course-up and
true motion (requires ship's speed and heading data) are available.
TM Disp Range: Selects how many times to expand the display range in the true mo-
tion mode. 1.3R (R=Range) and 1.6R are available.
Note: When you set [TM Disp Range] to 1.3R and [Full Screen Area] to 1.6R, the full
screen area for the TM mode becomes 1.6R.
Full Screen Area: Selects a configuration for the full screen display, 1.3R or 1.6R.
Bearing Ref: Selects how to reference bearing for the vertical bearing marker. The
choices are ship's heading and North.
TILT lever: Selects function of the TILT control. [Tilt] sets the tilt only. [Tilt & V1] sets
the bearing of the vertical 1 display in the vertical display and sets the tilt in the hori-
zontal display./
Auto Tilt: Selects the auto tilt angle, Wide (±2° to 10°, ±4° to 16°, ±6° to 20°) or Narrow
(±1° to 4°, ±2° to 6°, ±3° to 8°).
Net Course Mark: Inscribes/deletes the net course mark. For further details see
section 2.19.
Key Beep Volume: Sets the volume of the beep which sounds for key operation. The
setting range is 0-7. "0" turns off the key beep.
TimerDisplay: Set [ON] to show the timer window at the bottom left of the display. The
timer window can be moved by drag and drop operation. Operate the timer window as
shown below.
1. Select [ ] on the timer window and push the left-click button to start the timer.
The icon [ ] on the timer window changes to [ ● ].
2. Select [ ● ] on the timer window and push the left-click button to stop the timer.
The icon [ ● ] on the timer window changes to [ ].
3. Select [
7-4
] on the timer window and push the left-click button to reset the timer.