Dual Ethernet Ports; Ethernet Port Configurations; Port Forwarding; Ethernet Port Leds - Hughes HN7000S User Manual

Dual Ethernet ports The HN7700S has two RJ-45, 10/100BaseT Ethernet ports. The
Ethernet port configurations The Ethernet ports support the following configurations:
Port forwarding The port forwarding feature allows a user to configure the
The serial port supports a variety of protocols. See your service
provider for a list of supported protocols.
green and yellow LEDs on each port indicate link status and
Ethernet mode, as shown in Figure 6.
Figure 6: Ethernet port LEDs
The ports support a wide range of devices, including:
• PCs equipped with network interface cards (NICs)
• Hughes serial appliance, which can support up to four serial
devices
• Hubs
• Routers
• Switches
• Dual port, single subnet:
Only one Ethernet port is configured with an IP address at the
NOC, which means the terminal supports one subnet.
• Dual port, independent subnet:
Each Ethernet port is configured with a separate IP address at
the NOC, which means the terminal supports independent
subnets.
HN7700S to forward specific TCP and UDP traffic from the
Internet to servers on a LAN. For details, see Port Forwarding
Configuration page on page 30.
Chapter 1 • Introduction
1037073-0001 Revision E
9