IP Address/DHCP Settings
Ethernet Port Page
ATC Page
M2M Page
Ping Configuration:
12
The IP settings page under the Settings tab includes the following
fields:
Terminal Local IP address
DHCP Server enable
DHCP Address Range
Lease Time when Idle
Lease Time when Connected
Network Mode field: NAT or Relay (see Network Mode
section.)
The Ethernet Port settings page includes:
MAC Address filtering:
Ethernet MAC Address filtering enable tick box
Table of allowed Ethernet MAC addresses.
Wake On LAN (see Wake on Any Packet section):
Wake On LAN enable
Wake On LAN idle timer
Wake On LAN time of day
The ATC page includes:
ATC robustness On/Off radio button
ATC scan button
ATC scan status bar. This indicates the results of the last scan
or indicates if a scan is in progress.
The M2M page includes the following configurable parameters:
Context Watchdog - On/Off
Primary Ping Address
Secondary Ping Address
Tertiary Ping Address
Time between Pings (default is 8 hours)
Ping required - Yes/No If not set, then the system will not try
to ping on timer expiration if data was transmitted within the
watchdog period.