Fax Settings - Kodak Scan Station 520 EX Administrator's Manual

Fax settings

3-32
Following are procedures for configuring your fax settings.
NOTES:
• LDAP may be used to search for fax numbers that are stored on a
corporate address book. LDAP is not required to use the fax option.
• LDAP credentials for E-mail LDAP must be set up to properly use
LDAP for faxing. For more information refer to the section entitled,
"LDAP settings" earlier in this chapter.
1. Click the Fax icon.
2. Select LDAP Fax Field Tag.
3. Enter the LDAP Fax Field Tag for the tag to use when searching
LDAP for fax numbers. For more information, contact your network
administrator for the exact string to use (e.g., faxnumber).
4. Click Done.
5. If desired, select Sender's Fax Number. This number will be
displayed on the banner of outgoing faxes.
6. Enter the sender's fax number and click Done.
7. Select Outside Line Prefix.
8. Enter the prefix that the user needs to access an outside line
(e.g., 9, is frequently used and a comma "," may be used to insert a
pause). Each comma pauses the dialing sequence for about 3
seconds. You can use multiple commas to increase the pause time.
9. Click Done.
A-61628 December 2011