Adjustment After Roller And Clutch Replacement; Adjusting The Leading Edge Registration Of Image Printing - Kyocera Mita KM-2530 Service Manual

2DF

(3) Adjustment after roller and clutch replacement

Perform the following adjustment after refitting rollers and clutches.

(3-1) Adjusting the leading edge registration of image printing

Make the following adjustment if there is a regular error between the leading edges of the copy image and original.
U066
U034
(P. 1-6-29)
Caution:
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
Start
Enter maintenance mode.
Enter "034" using the numeric keys.
Press the start key.
Select the items to be adjusted.
Press the interrupt key.
Press the start key
to output a test pattern.
Is the leading edge
registration correct?
Yes
Press the stop/clear key to exit
maintenance mode.
End
1-6-10
U071
(P. 1-4-16)
Message display
RCL ON : Leading edge registration
RCL ON (DUP) : Leading edge registration for
duplex copying (second face)
RCL ON (BYP) : Leading edge registration for
feeding the bypass
Press the start key
The new setting is stored
For output example 1, increase
No
the value using the cursor down key.
For output example 2, decrease
the value using the cursor up key.
Setting range (initial setting)
RCL ON: –30.0 – +30.0 (0.5)
RCL ON (DUP): –10.0 – +10.0 (0)
RCL ON (BYP): –10.0 – +10.0 (-1.0)
Changing the value by 1 moves the
leading edge by 0.5 mm.
Leading edge registration (50
Correct image Output
example 1
Figure 1-6-21
±
1 mm)
Output
example 2