Installing The Job Separator (Option) - Kyocera Mita KM-2530 Service Manual

2DF

1-3-15 Installing the job separator (option)

Preparation
1. Insert the LED PCB into the job separator
and connect the 2-pin connector of the LED
PCB into the 2-pin connector of the job
separator.
* Arrange the wire into the two grooves of the
job separator.
2. Open the conveying cover and the front
cover.
3. Loosen the two left screws on the left side,
remove the screw on the front side, open the
hook on the right side, and remove the left
front cover.
4. Close the conveying cover and the front
cover.
5. Remove the two screws and remove the
ejection cover with the mounting plate.
1-3-56
2-pin connector
Job separator
Figure 1-3-120-1
Left front
cover
Screws
Figure 1-3-121
Ejection cover
Figure 1-3-122
2-pin connector
Grooves
LED PCB
Hook
Screw
Screws