Other Electrical Components - Kyocera Mita KM-2530 Service Manual

(4) Other electrical components

11
9
15
13 14
3
1
4
2
5
1. Upper paper feed clutch (PFCL-U) .............. Primary paper feed from the upper drawer.
2. Lower paper feed clutch (PFCL-L) ............... Primary paper feed from the lower drawer.
3. Feed clutch 1 (FCL1) ................................... Controls the drive of feed roller.
4. Feed clutch 2 (FCL2) ................................... Controls the drive of feed roller.
5. Feed clutch 3 (FCL3) ................................... Controls the drive of feed roller.
6. Bypass paper feed clutch (BYPPFCL) ......... Primary paper feed from the bypass tray.
7. Bypass feed clutch (BYPFCL) ..................... Controls the drive of bypass feed roller.
8. Registration clutch (RCL) ............................. Secondary paper feed.
9. Feedshift solenoid (FSSOL) ........................ Operates the feedshift guide.
10. Toner feed solenoid (TNFSOL) .................... Replenishes toner.
11. Exposure lamp (EL) ..................................... Exposes originals.
12. Cleaning lamp (CL) ...................................... Removes residual charge from the drum surface.
13. Fixing heater M (FH-M) ................................ Heats the heat roller.
14. Fixing heater S (FH-S) ................................. Heats the heat roller.
15. Fixing unit thermostat (FTS) ........................ Prevents overheating in the fixing section.
16. Total counter (TC) ........................................ Displays the total number of copies produced.
17. Drawer heater (DH) ..................................... Dehumidifies the drawer section.
10
12
8
7
17
Figure 2-2-4 Other electrical components
16
6
2DF
Machine front
Machine inside
Machine rear
2-2-5