Adjusting The Center Line Of Image Printing - Kyocera Mita KM-2530 Service Manual

2DF

(3-3) Adjusting the center line of image printing

Make the following adjustment if there is a regular error between the center lines of the copy image and original when
paper is fed from the drawer.
U067
U034
(P. 1-6-30)
Caution:
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
Start
Enter maintenance mode.
Enter "034" using the numeric keys.
Press the start key.
Select the item to be adjusted.
Press the interrupt key.
Press the start key to output a test
pattern.
Is the image correct?
Press the stop/clear key to exit
maintenance mode.
End
1-6-12
U072
(P. 1-4-17)
LSU OUT: Optical axis adjustment data
LSU OUT (DUP): Optical axis adjustment
For output example 1, decrease
No
the value using the cursor down key.
For output example 2, increase
the value using the cursor up key.
Yes
Setting range (initial setting)
LSU OUT: –10.0 – +10.0 (–7.2)
LSU OUT (DUP): –5.0 – +5.0 (0)
Changing the value by 1 moves the
center line by 0.1 mm.
Center line of printing
Correct image
example 1
Figure 1-6-23
data for duplex copying
(second face)
Press the start key.
The new setting is stored.
Output Output
example 2