5 VEHICLE PART REMOVAL
CAUTION
Be careful not to damage or lose any parts removed from the vehicle since they will be reused.
Negative battery cable
Cover assy-tonneau
Trunk
side
trim
Mounting hole
Cover assy-tonneau
Retract
Holder
Mounting hole
Negative battery cable disconnection
1. Set the selector lever to P range.
2. Disconnect the negative battery cable and wrap tape around it
Cover assy-tonneau removal
1. Remove the holder on the left end of the cover assy-tonneau
Holder
2. Retract the holder on the right end of the cover assy-tonneau
Trunk
side
trim
(AT vehicles only)
WARNING
When removing/installing the parts, park the vehicle on
level ground and apply the side brake securely. Be sure to
turn the ignition switch off, otherwise the vehicle can move,
causing personal injury or vehicle damage.
to insulate.
WARNING
When the negative battery cable is connected during
operation, it may cause electric shock or other personal
injuries. Disconnect the negative battery cable before
removal/installation.
Tightening torque : 4.0-6.0 N m
into the mounting hole of the trunk side trim.
and remove it into the mounting hole.
8
(if equipped)