Operation Check - Mazda CX-5 Installation Instructions Manual

8 OPERATION CHECK

1. Install in the reverse order of removal.
2. After verifying the harness routing, connect the negative battery cable.
CAUTION
Power window auto function
If the battery is disconnected, the automatic full open/close feature of the power window is disabled.
This feature can be recovered by the following procedure.
* For the power window with the automatic function, perform the all the initial settings.
Turn the ignition switch to the ON position.
Hold down the power window switch until the window is fully open.
Pull up the power window switch to close the window and continue to pull it up for about two seconds after it is fully
closed.
If the feature does not function even after the ignition switch is turned off, contact an Authorized Mazda Dealer.
TPMS system
If the battery is disconnected, the TPMS (Tire Pressure Monitoring System) initial setting is reset and the system may not
operate normally.
This feature can be recovered by the following procedure.
1.
Adjust the tire pressure (verify tire pressure using label on body side with driver's door open).
2.
Turn the ignition switch to the ON position.
3.
Press the TPMS (SET) switch (long-press it until TPMS warning light in meter flashes two times and a beep sounds one
time).
4.
Switch the ignition off.
5. If the TPMS warning light illuminates or flashes even though the above procedure has been performed,
contact an Authorized Mazda Dealer.
27