Control Unit Installation; Buzzer Installation - Mazda CX-5 Installation Instructions Manual

Control unit installation

Control unit
Ground wire (
Control unit
installation
1. Affix double-sided adhesive tape to the control unit.
2. Peel off the double-sided adhesive tape backing and adhere the
vehicle side)
control unit to the body panel of the lower part inside of the trunk
side trim (driver's side).
Front
1. Affix double-sided adhesive tape to the buzzer.
Always remove dirt or oil because the adhesive strength of
the double-sided adhesive tape weakens.
2. Peel off the double-sided adhesive tape backing and secure the
rear buzzer to the body panel of the upper inside part of the
trunk side trim (driver's side).
Always remove dirt or oil because the adhesive strength of
the double-sided adhesive tape weakens.
CAUTION
Always remove dirt or oil because the adhesive strength of
the double-sided adhesive tape weakens.
CAUTION
Always remove dirt or oil because the adhesive strength of
the double-sided adhesive tape weakens.
CAUTION
CAUTION
19