Before Installation; Required Tools - Mazda CX-5 Installation Instructions Manual

2 BEFORE INSTALLATION

REQUIRED TOOLS

Screwdriver (Flathead)
Pliers Masking tape
Drill ( 2 mm) Punch
WARNING
When the negative battery
cable is connected during
operation, it may cause
electric shock or other
personal injuries. Disconnect
the negative battery cable
before removal/installation.
CAUTION
Using improper tools may
cause damage and or broken
parts. Use the correct tool for
the job.
WARNING
When removing/installing the parts, park the vehicle on level ground and apply the side brake securely. Be
sure to turn the ignition switch off, otherwise the vehicle can move, causing personal injury or vehicle
damage.
Note
When the negative battery cable is removed, the clock, radio, trip meters and other memories will be erased.
Before performing work, record the content of the memory.
Refer to the Workshop Manual for removal and installation of vehicle parts.
Not following the procedures for removal/installation in the Workshop Manual could result in an accident or
vehicle malfunction.
Screwdriver (Phillips)
Electrical vinyl tape
Holesaw( 20 mm)
When connecting/dis-
connecting connectors, grasp
the connectors, not the wires.
Otherwise a short, an
accident from poor contact or
fire may occur.
Wrap protective tape around
screwdrivers and fastener
remover tools to prevent
scratching the vehicle.
Socket wrench
Mat IPA (Isopropyl alcohol)
File Utility knife
Do not pull the harness with
excessive force. Doing so
can cause a breakage or a
short-related accident, as
well as an electrical short or
fire.
Excessive length of tie wrap
may interfere with other parts
and cause damage.
Cut unnecessary part up to
about 5 mm {0.19 in} from
the fixed point.
4
Fastener remover
Secure the harness with the
band (part included) so it
doesn't dangle. If not, it may
cause a short, accident, or
fire.
Put the removed parts and
the parts in the kit on the
protective sheet to prevent
scratches.
Nipper