Optional On-Off Switch Installation (Kd33-V7-282) - Mazda CX-5 Installation Instructions Manual

Optional ON-OFF switch installation (KD33-V7-282)

Duct tape
Over-drilling prevention
Drill bit (shoulder
Sensor
hole
Drill( 2)
Drill 2
Center of the sensor hole
Surface of the
trunk side trim
Notch
Back-up sensor
ON-OFF switch
1. Wrap the drill bit with duct tape as shown in the figure.
2. Set the drill rotation to low speed.
Drill
Drill
Drill at low speed
3. With the drill bit pointed perpendicular to the bumper, drill a 2
4. Drill a 20 mm diam. hole from the center of the sensor hole
Holesaw( 20)
5. Remove burrs from the drilled holes using a round file.
6. Remove the paper backing from the back-up sensor ON-OFF
7. Route the system switch connector through the hole which was
Back-up sensor
ON-OFF switch
CAUTION
Always use a drill with a rotation speed adjustment,
otherwise the trunk side trim may deform.
Be careful when handling drills and other sharp objects.
To prevent scratching and over-drilling, always wrap the
drill bit with duct tape.
mm diam. hole in the marked position using a drill. (2 locations)
using a holesaw.
WARNING
Be careful when handling drills and other sharp objects.
If not handled properly, it could result in serious injury.
CAUTION
If the sensor is installed forcibly while the hole is small, it
could deform the bumper.
Make sure to remove burrs from the surface so that the
bumper surface is smooth.
switch (label) and adhere the back-up sensor ON-OFF switch
to the front side of the trunk side trim.
drilled from the surface of the trunk side trim using the hole saw,
align the system switch projection to the lower panel notch,
press it in the hole slowly, and secure it.
CAUTION
After installation, verify that the system switch is securely
pressed into the trunk side trim.
Align the rib side of the trunk side trim and the notch to set it.
18