Installation Of Sensor, On-Off Switch, Buzzer, And Unit; Sensor Installation - Mazda CX-5 Installation Instructions Manual

6. INSTALLATION OF SENSOR, ON-OFF SWITCH, BUZZER, AND UNIT

Sensor installation

Duct tape
Over-drilling prevention
Drill bit (shoulder
Sensor hole
(Surface of the
rear bumper)
Tab
Backside of
the rear
bumper
1. Wrap the drill bit with duct tape as shown in the figure.
2. Set the drill rotation to low speed.
Drill
Drill
Drill at low speed
3. Drill four 2 mm diam. holes in the 4 marked positions using a
4. Drill a 20 mm diam. hole from the center of the sensor hole
5. Remove burrs from the drilled holes using a utility knife.
6. Hold the outside of the round part of the back sensor and insert
Washer
Sensor
7. After inserting the washer into the sensor from the backside of
8. Pull up the sensor tab using a flathead screwdriver.
Top
Vehicle front
Washer
Sensor
CAUTION
Always use a drill with a rotation speed adjustment,
otherwise the rear bumper may deform.
Be careful when handling drills and other sharp objects.
To prevent scratching and over-drilling, always wrap the
drill bit with duct tape.
drill with the drill bit pointed at a angle of 0 to 12 degrees to the
bumper.
using a hole saw.
WARNING
Be careful when handling drills and other sharp objects.
If not handled properly, it could result in serious injury.
CAUTION
If the sensor is installed forcibly while the hole is small, it
could deform the bumper.
Make sure to remove burrs from the surface so that the
bumper surface is smooth.
the sensor into the hole slowly.
the bumper, press the sensor into the bumper and secure it.
CAUTION
Insert the sensor so that the sensor tab is facing upward.
After installation, verify that the corner sensor and back
sensor are securely pressed to the bumper.
17