Gigaset SX763 First Steps page 91

ì
Choose the desired Registration Mode:
– Push Button
Click OK to start the WPS registration.
This function corresponds to pressing the Scan button on the device's back panel,
if available.
Once WPS registration is activated, the device searches for a WPS client within
range. Any WPS client within range that activates the WPS function during the
two-minute interval receives the Gigaset SX763 WLAN dsl security data (SSID and
pre-shared key) and is thereby registered.
The registration progress is shown in the window.
You can also follow the registration process via the LED display (see page 34).
If more than one client tries to register within the two minutes, an error message
is displayed. You may retry the WPS registration after a short time.
If an external client succeeds in registering, the LED (see page 34) displays a suc-
cessful WPS registration. The desired client in you network, however, has no con-
nection to the Gigaset SX763 WLAN dsl and displays a registration failure. In this
case you should change the pre-shared key (WPA2-PSK/WPA-PSK) as soon as pos-
sible and then perform WPS registration via PIN (see below).
– Send own PIN
An automatically generated PIN is shown.
If you want to create a new PIN, click Generate PIN.
Click OK to activate your settings.
Enter the generated PIN on all WLAN partner devices that are to establish a
connection.
– Enter partner device PIN
You would use this option if you have created a PIN at the desired client. Enter the
PIN of the WLAN partner device and click OK to activate your settings.
Note:
If you have activated access control via the MAC address filter, you have to include the
clients in the MAC address list before registering via WPS (see page 98).
Configuring Advanced Settings
91