Reports; Start-Up Report - Buderus Logamax plus GB162-L.B. 80 kW Installation Instructions Manual

15

Reports

15 Reports
15.1

Start-up report

▶ Enter your signature and the date after completing the start-up activities.
Start-up activities
1. Check for gas leaks
2. Fill the heating system
- Pre-pressure expansion vessel (refer to the installation
instructions for the expansion - vessel)
- Heating system filling pressure
3. Fill the condensate trap with water
4. Write down the gas characteristics
5. Bleed the gas supply valve
6. Check the air/flue gas connection
7. Checking the appliance configuration
8. Measure the gas inlet pressure (working pressure)
9. Carry out a leakage test in operating conditions
10. Check and adjust the flue gases CO
11. Carry out a function test
- Measure the ionization current
12. Measure the pH-value
13. Boiler settings
14. Final activities
- Close the boiler door and the control panel
- Hand over
Confirming proper start-up
Table 27 Start-up report
56
Page
page 34
page 34
page 35
Heat input
Heat output
page 35
page 36
page 36
page 36
page 38
emissions page 38
2
page 39
page 39
page 40
page 41
Company stamp/signature/date
Measurement results Remarks


_____________ psi
_____________ psi

3
_____________ btu/ft.
3
_____________ btu/PM



_____________ " W.C.

_____________ ppm

μA
_____________
Fill in the record book


Logamax plus GB162-L.B. 80 kW / 100 kW – 6720645916 (2014/10)