Replacing The Fuse - Wyse WY-60 Maintenance Manual

,
3.
Disconnect the keyboard cable on the left side of the
terminal enclosure.
4. Remove the two No.2 Phillips screws from the rear panel of
the terminal enclosure.
5. Remove the two No.2 Phillips screws from the bottom of the
terminal enclosure, next to the back bezel.
6. Lift off the terminal enclosure.
Replacing the Fuse
Tool required:
o Fuse puller or screwdriver
The terminal has a BEL5MT2 fuse, rated 2 amps, 125 volts
(international rating is 1.6 amps, 250 volts). See Figure 2-6
for the fuse location on the terminal PCB.
To check or replace the fuse, follow these steps:
1.
Remove the terminal enclosure.
See Figure 2-5.
2. Use a fuse puller to remove the fuse.
Figure 2-6 Replacing the Fuse
2-10