Replacing The Fuse - Wyse WY-30 Maintenance Manual

Replacing the Fuse
Tool required: Fuse puller or screwdriver
The terminal has one fuse, rated 2 amps, 125 volts. See Figure
2-4 for the fuse location on the terminal PCB.
To check or replace the fuse, follow these steps:
1. Remove the terminal enclosure.
2. Use a fuse puller to remove the suspected fuse.
3.
Check the fuse. If the fuse is broken or blackened, push a
new fuse into the fuse socket.
If the fuse is good, push it back into the fuse socket.
4. Replace the terminal enclosure (see "Replacing the Termina
EnClosure" for instructions).
Figure 2-4 Replacing the Fuse
2-7