Toshiba RAS-M10PKVP-E Service Manual page 125

No. Part name
2 Discharge 1. Detachment
port cabinet
1) Perform work of Detachment 1 of 1.
2) Take off screws for the discharge port cabinet and the
partition plate. (ST1T Ø4 × 8, 3 pcs.)
3) Take off screws for the discharge port cabinet and the
bottom plate. (Hexagonal screw Ø4 × 10, 2 pcs.)
4) Take off screws for the discharge port cabinet and the
motor base. (ST1T Ø4 × 8, 2 pcs.)
5) Take off screw for the discharge port cabinet and the heat
exchanger. (ST1T Ø4 × 8, 1 pc.)
6) Take off screws for the discharge port cabinet and the fin
guard. (Hexagonal screw Ø4 × 10, 2 pcs.)
3 Rear cabinet 1. Detachment
1) Perform work of Detachment 1 of 1.
2) Take off screw for the rear cabinet and the valve fixed
board. (Hexagonal screw Ø4 × 10, 2 pcs.)
3) Take off screw for the rear cabinet and the anchor board.
(Hexagonal screw Ø4 × 10, 1 pc.)
4) Take off screws for the rear cabinet and the heat
exchanger. (Hexagonal screw Ø4 × 10, 3 pcs.)
5) Remove the rear cabinet by shifting it obliquely backward
and upward.
Procedure
– 125 –
Remarks
Heat exchanger
Motor base
Fin guard
Partition plate
Discharge port cabinet
Rear cabinet
Inverter
assembly
Rear cabinet