BMW R 1200 R Rider's Manual page 107

Loosen adjusting screws 1.
Push two mounts 2 far
enough apart that front
forks fit between them.
Use locating pins 3 to set
front wheel stand to desired
height.
Center the front wheel stand
relative to the front wheel
and push it against the front
axle.
Align two mounts 2 so that
front forks rest securely on
them.
Tighten adjusting screws 1.
If the motorcycle is rest-
ing on the center stand:
The motorcycle is raised too
far at the front, the center
stand lifts off the ground and
the motorcycle can tip over to
the side.
When raising the motorcycle,
make sure that the center
stand remains on the
ground.
Apply uniform pressure to
push the front wheel stand
down and raise the motor-
cycle.
7
105
z